Industry News · Technical Support · Product Cases
A veteran engineer with 30 years of experience explains the YB/T 4001.1 standard, sizing calculations and installation essentials, helping you purchase scientifically and avoid detours.
WhatsApp & E-mail support | Free sizing & quotation
Steel grating is a steel product made by cross-arranging flat bearing bars with cross bars (twisted square bars, square bars, round bars or flat bars) at set pitches and welding them into a panel with square openings; the cross bars are usually twisted square bars. Platform steel grating is normally made of carbon steel with a hot-dip galvanized surface to prevent oxidation, though stainless steel is also an option. Marking method for hot-dip galvanized steel grating: 1. Flat bars 65mm-200mm wide and 5...

Stainless steel grating can rust under certain conditions. It resists atmospheric oxidation - stainlessness - and also resists acids, alkalis and salts - corrosion resistance. However, its corrosion resistance varies with the chemical composition of the steel itself, its processing state, service conditions and the type of environmental medium. Ordinary stainless steel usually contains no less than 12% chromium, with higher...

In daily use of galvanized steel grating, corrosion protection is what users value most. Some manufacturers fail to pay enough attention to this, so their products do not adapt well to actual site conditions and their service life suffers. Buyers may have many requirements for steel grating, but the one that deserves attention is still the corrosion performance of the product itself. Steel grating prod...

Steel grating fixing methods: either welding or fastening with installation clips. Welding gives a permanent fix that will not work loose; installation clips do not damage the hot-dip zinc coating and allow easy removal. The safest method is to omit the lower clip and weld the screw head upside down onto the beam, ensuring the grating cannot slide off if a clip loosens. The anti-slip layer is bonded to the metal panel surface with a primer, and consists of a sand layer. The sand is...

What technical requirements does the petrochemical industry place on galvanized steel grating? Material requirements: bearing bars, cross bars and edge bands are generally carbon structural steel or stainless steel. The mechanical properties and chemical composition of carbon structural steel should comply with the Q-A provisions of GB/T700-988; stainless steel should meet the material requirements of GB0-99. Layout requirements: the manufacturer should work from the steel platform member and opening layout drawings to arrange...
