Industry News · Technical Support · Product Cases
A veteran engineer with 30 years of experience explains the YB/T 4001.1 standard, sizing calculations and installation essentials, helping you purchase scientifically and avoid detours.
WhatsApp & E-mail support | Free sizing & quotation
1. The design load of steel grating working platforms shall comply with GB 50009. 2. Steel grating working platforms are usually designed with a uniformly distributed load of 2kN/m². At the most unfavorable position of the platform, a 20m×20mm area can bear a concentrated load of 1.5kN.

Interpreting steel grating specifications: we take G323/30/100, the most typical specification in the steel grating industry, as an example: 1. In G323/30/100, the leading "G" indicates that this model is a steel grating type; "SG" would indicate a serrated steel grating with uniform serrations on the bearing bars. 2. In G323/30/100, the first two digits "32" of "323" indicate that the bearing bar width is 32mm,...

Bearing bar: the main material of steel grating, a uniform rolled flat bar for bearing loads, resting on steel beams at both ends. Cross bar: a twisted square bar of square cross-section, welded orthogonally onto the bearing bars to fix them. Edging bar: a flat bar with the same cross-section as the bearing bar, welded to the ends of the bearing bars, used for edging or notching. Panel length: the overall dimension measured parallel to the bearing bars,...

Whether steel stair treads are fixed by screws or welding: bolt-fixed treads require a drilled side plate at the rear; direct welding does not require a thickened side plate. Stair treads generally use hot-dip galvanizing or spray-painted surface treatment; spray-painted ones should be coated with anti-rust paint before the topcoat for long-term corrosion protection. Galvanized steel grating stair treads are stairs made of steel grating for platforms; depending on the installation method, they are generally welded...

Steel covers can be fixed by welding or by mounting clips. Welding offers long-term fixing without loosening; the detailed position is one edging bar at each corner of the product, with a fillet weld no shorter than 20mm and no less than 3mm high. The advantage of mounting clips is that they do not damage the hot-dip galvanized coating and allow easy disassembly; at least 4 sets of clips are required per panel, increasing with panel length; the method uses no lower clip, but...
