Anping, Hebei · China's Wire Mesh Capital | APG Steel Grating — Direct Manufacturer of Hot-Dip Galvanized Steel Grating Instant QuoteSitemap

Steel Grating · Stair Treads · Covers

  • 20-Year Manufacturer
Industry News · Standard Interpretation

Steel Grating Standards & Technical Insights

Industry News · Technical Support · Product Cases

A veteran engineer with 30 years of experience explains the YB/T 4001.1 standard, sizing calculations and installation essentials, helping you purchase scientifically and avoid detours.

WhatsApp & E-mail support | Free sizing & quotation

  • Palletized hot-dip galvanized steel grating panels packed for shipment
  • Stacked hot-dip galvanized steel grating panels in factory yard
  • Double-tier galvanized steel grating stair treads with nosing
You are here: Home > Industry News > Industry News
Contact Us

Steel Grating Factory

Address: East Industrial Park, Anping County
WhatsApp: +86 133 2318 8871
E-mail: [email protected]

How to Read Steel Grating Model Markings? Understand G405/30/100 in One Minute

Published: 2026-07-22Popularity: 1

On steel grating, this article covers the six-segment marking rules, basic concepts, and specification parameters in turn, giving actionable criteria rather than theory alone. Those with drawings or site dimensions can check against the key points; hot-dip galvanized steel grating can follow the same order.

The Six-Segment Marking Rules

Chapter 5 of YB/T 4001.1-2019 specifies that a steel grating model consists of six parts, in order: bearing bar specifications, bearing bar pitch, cross bar pitch, construction type, cross-section shape, and surface treatment.

Take the standard's example G405/30/100U as an example, and it becomes clear once broken down:

Close-up of steel grating model marking

▲ Steel grating model marking - the six positions represent six parameters

Position Code Meaning
1. Flat bar specificationsG40540mm wide × 5mm thick
2. Bearing bar pitch3030mm center pitch
3. Cross bar pitch100100mm center pitch
4. Construction type(omitted)W = welded (omitted)
5. Cross-section shape(omitted)F = rectangular section (omitted)
6. Surface treatmentUU = untreated (G = galvanized, omitted)

So G405/30/100U means:Bearing bars 40×5mm, pitch 30mm, cross bar pitch 100mm, welded type, rectangular section, untreated surface.

Another example: G325/30/100 means bearing bars 32×5mm, pitch 30mm, cross bar pitch 100mm, welded, rectangular section, hot-dip galvanized. Much easier to understand, right?

-- Lao Liang @ Anping Steel Grating Factory, July 2026

Bigger is not always better. Steel grating selection should be as economical as possible while meeting load requirements; over-thickening increases self-weight and cost and complicates installation. The product page offers a fuller comparison for galvanized grating; refer to it before deciding.

Further notes: Common combinations of hot-dip galvanized steel grating and galvanized grating

If a project uses both hot-dip galvanized steel grating and galvanized grating, we recommend planning them on the same layout drawing. This way edge closing, fixing and cutouts at junctions can be handled uniformly, avoiding dimension conflicts during installation and making later maintenance easier.

If you already have drawings or site dimensions, submit them directly and we will help verify specifications and layout, avoiding on-site cutting and rework caused by mismatched models. Without drawings, site photos and approximate dimensions are enough for an estimate.

Related Products